Call Us Toll-Free Today: 1.800.231.0734 | E-mail: sales@sealfast.com
Search Catalog :
GO
All Categories > Industrial Clamps and Accessories > Oetiker Tools & Clamps > Item # 18500056  

Item # 18500056, SK 1098 - With Standard Jaw Pincers


    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

Service Kit With Standard Jaw Pincers




Specifications  · Note  · Installation

Specifications

Kit Content

Plastic kit box contains :

Standard Jaw Pincers
2-Ear Clamps :
All Zinc plated
Part # 1098
15 of 0709 (5/16")
15 of 0911 (7/16")
15 of 1113 (1/2")
15 of 1315 (9/16")
15 of 1518 (5/8")
15 of 1720 (3/4")
15 of 2023 (7/8"


Note
Once an Oetiker Eared Clamp has been applied, then removed, it must not be reused.



Installation

    When installing Oetiker 2-Ear Clamps, close first ear, then the second. Once the second ear is closed, the first one will open slightly, simply squeeze again. Do not squeeze each ear more than twice. On Stepless Ear Clamps, simply close the single ear.


    With either clamp, if properly sized, the ear will spring back naturally to provide a desired gap of approximately 1.5 mm. That is necessary for Oetiker eared clamps to perform to their maximum. If clamp ears can be closed all the way, the clamp size selected is too big and the next smaller size clamp should be ordered.

    How To Apply:
    This procedure works for either eared clamp. Position clamp on hose as illustrated.


    Give each ear a firm squeeze with your Oetiker Pincers.


    Where access to ear is difficult use Oetiker's Side Jaw Pincers Model 1099.


    How To Remove:
    Grip the outer edge of ear firmly and cut through it with either pincers.


    Cut the ear by taking several small bites at its base with either pincers. The grip ear firmly and twist it off.


    Stepless clamps may be easily removed by prying end up with a common screwdriver.




Site created by ThomasNet Web Solutions